15
DTP CrossPoint 4K Series • Installation
ATTENTION:
•
For unbalanced audio output, connect the sleeves to
the ground contact.
DO NOT
connect the sleeves to the
negative (-) contacts.
•
Connectez ce port au port d’expansion sur un processeur
DMP d’Extron compatible. Ne connectez
PAS
ce port à un
port LAN ou d’alimentation via Ethernet ; le matériel pourrait
être endommagé.
NOTES:
•
The length of exposed wires is important. The ideal length is
3/16 inch (5 mm).
•
If the stripped section of wire is longer than 3/16 inch, the
exposed wires may touch, causing a short circuit.
•
If the stripped section of wire is shorter than 3/16 inch,
wires can be easily pulled out even if tightly fastened.
•
Do not tin the power supply leads. Tinned wires are not as
secure in the connector and could be pulled out.
RS-232 and IR connectors
Figure 16 shows how to wire the RS-232 and IR connector.
Tx/Rx
Pins
Rx Tx
Tx Rx
Gnd
Gnd
RS-232 Device
IR Device
RS-232 IR
Tx
Rx
Tx
Rx
G
Tx
Gnd
RS-232 Device
Rx
Tx
Rx
G
REMOTE
OVER TP
Figure 16.
RS-232 and IR Connector Wiring
NOTE:
The length of exposed wires is important (see the
above for more information).
Summary of Contents for DTP CrossPoint 4K Series
Page 6: ......
