31
DTP CrossPoint 4K Series • Remote Control
Starting the DSP Conigurator Program
The DSP Conigurator can connect to the switcher via any rear
panel LAN port or the front panel Coniguration port.
NOTE:
Extron recommends connection via an Ethernet LAN
port for the DSP Configurator program.
Start the DSP Conigurator program, as follows:
1.
Click
Start
>
Programs
>
Extron
Electronics
>
DSP
Configurator
>
DSP
Configurator
. The DSP Conigurator
Startup
screen opens (see igure 24).
Figure 24.
DSP Conigurator Screen and Device Selection
TIP:
You can also launch the DSP Configurator program
from within the Product Configuration Software.
2.
Select the DTP CrossPoint switcher in the drop-down menu
and click
OK
.
TIP:
If you have only DTP CrossPoint switchers of the
same model, click
Always
perform
the
selected
action
to eliminate step 2 in future startups.
The DSP Conigurator program starts in Emulate mode (see
on the next page).
NOTE:
In Emulate mode, changes and settings are stored
in the PC and not sent to the switcher until you select Live
mode and "push" the settings to the switcher. See the
DTP CrossPoint 4K Series User Guide
.
Summary of Contents for DTP CrossPoint 4K Series
Page 6: ......
