10/100/1000 RJ45 port LED state indicators
The 10/100/1000 RJ45 ports used in the system have two LEDs. Each LED is located on either
side of the RJ45 tab. The right LED is labeled as “Speed” and the left LED is labeled as “Link/
Activity”. The following table shows the status of the two LEDs:
Table 19: 10/100/1000 RJ45 port LED state indicators
Label
Color and Status
Description
Speed
Off
The port is operating at 10Mbps
mode.
Amber (solid)
The port is operating at 100Mbps
mode.
Green (solid)
The port is operating at 1Gbps.
Link/Activity
Green (solid)
The port has link and there is no
data activity.
Green (blinking)
The port has link and there is data
activity.
Green (slow blinking)
The port is administratively
disabled.
Channelized LED state indicators
The following table describes the channelization LED state indications provided by the color.
These ports use
In Use
Link/Act
to indicate whether or not the link is established.
Table 20: Channelized LED state indicators
Label
Color and Status
Description
Opt
Off
Clear channel (40GB) mode of
operation
Green (solid)
Channelized mode of operatoin
Link/Act
Off
All ports are link down, no faults
Amber (blinking)
One or more ports have local fault
Amber (steady)
One or more ports have remote
fault
Green (slow blinking)
One or more ports are
administratively down
Note:
Remote fault has priority
over local fault
Table continues…
Installing the Virtual Services Platform 8000 Series
December 2017
Installing the VSP 8000 Series
88
