Note:
The levers are designed to stay in the position shown when the module is inserted into
the chassis. The levers are pulled upwards to extract the module.
If you have to remove a module, loosen the two screws that secure the module to the
chassis and rotate the extract levers up to eject the module from the chassis. Remove the
module, and then either install another module or replace the module bay cover.
Important:
You must have either a module or a module bay cover in each bay to ensure proper
ventilation. Leaving a module bay unpopulated or uncovered impairs the ability of the
fans to cool the chassis.
Hot swap of VSP 8400 Ethernet Switch Module
Hot swap is the ability to add, remove, or replace system components without shutting down the
system and without interrupting the operation of the system. The VSP 8400 supports the hot swap
of ESMs, power supply units, and fan modules.
The following table explains the methods of hot swapping in VSP 8400.
Installing the Virtual Services Platform 8000 Series
December 2017
Installing the VSP 8000 Series
30
