Extreme Networks Summit WM20, User Manual

Page: 241 / 270

Summit WM20 User Guide, Software Release 4.2
241
B Regulatory Information
This section provides the regulatory information for the Summit WM20 series switch and Altitude 350-2
Access Point.
Configuration of the Altitude 350-2 frequencies and power output are controlled by the regional
software purchased with the Summit WM series switch and are downloaded from the sever upon initial
set-up. A company is only allowed to download the software related it it's geographic location, thus
allowing the proper set-up of Access points in accordance with local laws and regulation. The Altitude
350-2 AP must not be operated until proper regional software is downloaded and properly configured.
NOTE
Please refer to http://www.extremenetworks.com/go/rfcertification.htm for latest regulatory information regarding
operation of the Altitude 350-2 Access Point.
Only authorized Extreme Networks service personnel are permitted to service the system. Procedures that should be
performed only by Extreme Networks personnel are clearly identified in this guide.
Changes or modifications made to the Summit WM series switch or the Altitude APs which are not expressly
approved by Extreme and party responsible for compliance upon installation could void the user's authority to
operate the equipment.
If agency verification testing is required, contact Extreme Networks for additional instructions.
Summit WM20
Safety Standards
North American Safety of ITE:
●
UL 60950-1:2003 1st Ed., Listed Device (US)
●
CSA 22.2#60950-1-03 1st Ed. (Canada)
European Safety of ITE:
●
EN60950-1:2001+A11
●
GS Mark, DEMKO, EN 60950-1:2001+A11
●
73/23/EEC Low Voltage Directive
International Safety of ITE:
●
CB Report & Certificate per IEC 60950-1:2001+ Country Deviations
●
ANATEL, Resolution 238 (Brazil)
●
NOM/NYCE (Mexico)