Page 23
8. USING THE STOVE
The stove you have pur
chased uses pellets as fuel. This type of material is produced from natural
waste from woodworking. By means of a special process, which does not require the use of any
binders or additives, the shavings are compressed in industrial machines under high pressure and
become solid wooden pellets. IT IS STRICTLY FORBIDDEN to burn any other material besides
pellets in our stove.
Failure to respect these instructions will void all warranties and may jeopardise the safety of the
appliance.
The first two or three times the stove is lit, the following recommendations should be observed:
•
No children should be present, as the vapours emitted can be harmful for health. Adults,
too, should not stay in the vicinity for very long.
•
Do not touch the surfaces, as they could still be unstable.
•
Air the room thoroughly several times.
•
The hardening of the surfaces is completed after several heating processes.
1-
This stove
must no
t be used as a waste incinerator.
9. LIGHTING
1.
Before proceeding, check to make sure that:
a)
the hopper is loaded
b)
the combustion chamber is clean
c)
the burn pot is clean
d)
the front door and the pellet drawer are closed
e)
the power outlet is connected
f)
the switch on the back of the stove is in position 1
2.
Press button
1
for thr
ee seconds;
display
D1
will show the message “
START
”.
During this
stage, the stove car
ries out an automatic check on the efficiency of each single electrical
component. When this cycle is completed, display
D1
shows the message “
ACCENSIONE
15’
” (
the number of minutes for which the stove
attempts the lighting stage, decreasing by
1 every minute that passes).
NOTE:
The first time the stove is used, even if the hopper is
loaded with pellets, it is possible that the pellets are not distributed to the combustion
chamber for the first 15 minutes because the worm screw for loading the pellets is empty.
If the stove has not developed a flame after the fifteen minutes have elapsed, the display
shows the message “
MANCATA FIAMMA
”. In this case, press button 1 for three seconds
until D1 shows the message
“OFF”
. Then repeat steps 1 and 2.
3.
If steps 1 and 2 are carried out correctly, as soon as the flame develops the stove enters
the start-up phase (“
AVVIAMENTO 07
” ).
4.
After the start-up phase, the stove goes into normal operation: display
D1
shows the room
temperature and
D2
shows the heat setting.
WARNING!
1. NEVER USE FLAMMABLE LIQUIDS FOR LIGHTING.
2. WHEN FILLING, DO NOT BRING THE SACK OF PELLETS INTO CONT
ACT WITH THE
HOT STOVE.
N.B.
:
In the event of continued lighting failur
es, contact an authorised technician.
Summary of Contents for INSERTO COMFORT MINI
