30
The setting "Burner" is used for gasprojectors with
receivers, and can't be used for the X2 Wave Flamer.
After changing the box number to liquid, you can select the correct amount of Wave Flamers used per
box number. You can reset the the number of boxes with the button "Reset amount of boxes".
Next, you can set the correct amount. This is mainly used for the correct display of the simulation. In
the following example, we will use 5 devices on box number 1, and one device on box number 2.
10.2.2 SIMULATION W INDOW
After selecting the box numbers, you can close or open the simulation window at any time by clicking
the checkbox "
Simulation
" in the lower right corner of the software.
In the simulation window, the previously assigned Wave Flamer boxes will now be shown in their
correct amount.
The number below the shown Wave Flamers (grey boxes) is the box number of the device. The Wave
Flamers can be moved freely within this window by clicking and dragging them with the left mouse
button. An optional grid (Checkbox "
Show grid
") helps with the positioning.
Should Wave Flamers be inverted for the show (software), or be placed the other way, then you can
change this too in the simulation. With a doubleclick into the corresponding devices box, it will be
defined as inverted. This is marked by the letter "i" (see right most Wave Flamer in the graphic below).