304.8 mm
/ 12 in.
46
9.9
m
m
/ 1
8.5
in
.
LP- Gas Supply System
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Proper Placement And Clearance Of Grill
•
•
WARNING
If the information is not followedexactly, a
fire resulting in death or serious injury
could occur.
A 20lb tank of approximately 304.8 mm /
12 in diameter by 469.9 mm / 18.5 in high
is the maximum size LP gas tank to use.
The LP gas supply cylinder to be used must be constructed
and marked in accordance with the specifications for LP - Gas
cylinder of the U.S. Department of Transportation (DOT) or
the National Standard of Canada ,CAN/CSA - B339, Cylinders,
Spheres and Tubes for Transportation of Dangerous Goods
and Commission .
DO NOT use this appliance under overhead combustible
surfaces. This outdoors cooking appliance is not intend to be
installed in or on recreational vehicles and/or boats.
LP gas tank must be stored outdoors in a well - ventilated area
and out of reach of children. Disconnected LP gas tanks must
not be stored in a building, garage or any other enclosed area.
•
Do Not obstruct the flow of ventilation air around the gas grill
housing. Only use the regulator and the hose assembly
supplied with your gas grill. Replacement regulators and hose
assemblies must be those specified in this manual.
•
The regulator and hose assembly must be inspected before
each use of the grill. If there is excessive abrasion or wear or if
the hose is cut, it must be replaced prior to the grill being put
into operation. The replacement hose assembly shall be that
specified by the manufacturer.
•
Pressure regulator and hose assembly supplied with the
outdoor cooking gas appliance must be used. Never substi-
tute other types of regulator. Contact customer service for
manufacturer specified replacement parts.
•
This outdoor cooking appliance is equipped with a pressure
regulator comply with the standard for Pressure Regulating
Valves for LP Gas ANSI/ UL 144.
•
The gas grill is designed for optimum performance without
the use of briquettes. Do not place briquettes on the radiant
as this will block off the area for the grill burners to vent.
Adding briquettes can damage ignition components and
knobs, and void the warranty.
•
Keep the back and side cart free and clear from debris. Keep
any electrical supply cord, or the rotisserie motor cord away
from the heated areas of the grill.
•
Never use the grill in extremely windy conditions. If located in
a consistently windy area (oceanfront, mountaintop, etc.) a
windbreak will be required. Always adhere to the specified
clearance.
•
Never use a dented or rusty propane tank.
•
Keep any electrical supply cord and the fuel supply hose away
from any heated surface.
•
While lighting, keep your face and hands as far away from the
grill as possible.
•
Burner adjustment should only be performed after the burner
have cooled.
Your grill will get very hot. Never lean over the cooking area while
using your grill. Do not touch cooking surfaces, grill housing, lid or
any other grill parts while the grill is in operation, or until the gas
grill has cooled down after use.
Failure to comply with these instru
cti
ons may result in serious
bodily injury.
CAUTION: TO ENSURE CONTINUED PROTECTION
AGAINST RISK OF ELECTRIC SHOCK, CONNECT TO
PROPERLY GROUNDED OUTLETS ONLY, TO REDUCE
THE RISK OF ELECTRIC SHOCK, KEEP EXTENSION CORD
CONNECTION DRY AND OFF THE GROUND.
•
Do not use briquettes of any kind in the gas grill.
The LP gas tank must have a shutoff valve terminating in an LP
valve outlet that is compatible with a Type 1. LP gas supply
cylinder must have a shut off valve terminating in a valve
outlet specified for connection type QCC1 in the standard for
compressed gas cylinder valve outlet and inlet connection
ANSI/CGA-V-1 as applicable. LP gas supply cylinder must be
fitted with an Overfill Protection Device (O.P.D) The LP gas
tank must also have a safety relief device that has a direct
connection with the vapor space of the tank. This safety
feature prevents the tank from being overfilled, which can
cause malfunction of the LP gas tank, regulator and/or grill.
The tank supply system must be arranged for vapor
withdrawal.
The LP gas tank used must have a collar to protect the tank
valve.
Place dust cap on cylinder valve outlet whenever the cylinder
is not in use. Only install the type of dust cap onthe cylinder
valve outlet that is provided with the cylinder valve. Other
types of cap or plugs may result in leakage of propane.
Never connect an unregulated LP gas tank to your gas grill.
This outdoor cooking gas appliance is equipped with a high
capacity hose/regulator assembly for connection to a
standard 20 lb Liquid propane cylinder.
Have your LP gas tank filled by a reputable propane gas dealer
and visually inspected and re - qualified at each filling.
Do not store a spare LP gas cylinder under or near this appli-
ance.
Never fill the cylinder beyond 80 percent full.
Always keep LP gas tanks in an upright position.
Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
Storage of an outdoor cooking gas appliance indoors is
permissible only if the cylinder is disconnected and removed
from the outdoor cooking gas appliance.
When your gas grill is not in use the gas must be turned off at
LP gas tank.
Never use your grill in a garage, porch, shed, breezeway or
any other enclosed area. Your grill is to be used outdoors
only. Do Not install this unit into combustible enclosures.
Minimum clearance from sides and back of unit to combus-
tible construction, 91 cm / 36 in. from sides and 91 cm / 36 in.
from back.
06
