Page 4 of 7
109-6609 Rev. C
Assemble the Fill Sensor Alarm
Bracket
1. Apply the decal (109-5606) to the front of the LH
ROPS tube as shown in Figure 4. Locate the fill
sensor alarm bracket, u-bolt and hardware.
Assemble to top of LH ROPS tube.
FIGURE 4
Assemble the Fill Sensor Alarm
1. The fill sensor alarm is pre-assembled to the wiring
harness. Install alarm to bracket by unscrewing the
retaining ring, insert alarm through large hole in
bracket, and reinstall retaining ring hand tight. See
Figure 5.
2. Retain wire harness to alarm bracket by installing
the barbed “push in” into extra hole of alarm
bracket. See Figure 5.
FIGURE 5
Install Hopper Assembly
Note: Reference the previous assembly
diagrams for the Item numbers called out in the
installation instructions.
1. Remove the 2 bolts in the rear of the lower
ROPS tubes on each side to allow for
installation of the Ultra Vac.
2. Install the mount weldment (Item 4) loosely to
the rear of the machine using (4) 3/8-16 x 1.5”
screws, 3/8” spring disc washers and 3/8”
whizlock nuts provided. Make sure that the
raised portion of the spring disk washer faces
the head of the screw. (See Figure 6).
FIGURE 6
3. Loosen (but do not remove) the remaining 2
front screws on each side retaining the lower
ROPS tubes to the frame.
4. Apply a light coat of grease to the top surface of
the mount weldment. Install the hopper
assembly (Item 1) by laying the hopper
assembly back on the door, pivot the lower links
forward and slip the ends over the pins on the
mount weldment. Secure the assembly to the
mount using hairpins (Item 9). See Figure 7.
FIGURE 7
