EXFO T200S, User Manual, Page: 119 / 146

SCPI Command Reference
Tunable Laser Source
113
T200S Specific Commands
[SOURce]:SWEep:REST
Description
This command sets the spectrum position when the source return
to idle after completion of a sweep sequence.
At *RST, this value is set to START.
Syntax [:SOURce]:SWEep:REST<wsp><position>
Parameter(s)
position :
Position of the laser after sweep sequence completion. Possible
values are:
³
STARt: on sweep sequence completion, the source goes back
to the sweep start position as specified by the commands
[SOURce]:FREQuency:SWEep:STARt
on page 102 and
[SOURce]:WAVelength:SWEep:STARt
on page 122.
³
STOP: on sweep sequence completion, the source stays at the
sweep stop position.
If the sweep sequence is completed normally then the
position is specified by the commands
[SOURce]:FREQuency:SWEep:STOP on page 104 and
[SOURce]:WAVelength:SWEep:STOP on page 124.
If the sequence is canceled then the position will be
anywhere within the sweep range.
Example(s)
SOUR:SWE:REST STOP
SOUR:SWE:REST? returns STOP
See Also
[SOURce]:FREQuency:SWEep:STARt on page 102
[SOURce]:FREQuency:SWEep:STOP on page 104
[SOURce]:SWEep:REST?
on page 114
[SOURce]:WAVelength:SWEep:STARt on page 122
[SOURce]:WAVelength:SWEep:STOP on page 124