Tunable Laser
Source
FLS-2800
FLS-2800 (v1.1)
18
9.
Tunable Laser Manager Software
Start-up
When the Tunable Laser Manager
software is run, the start-up screen will
be displayed. Click anywhere within the
window to initiate the
Device Discovery
.
Click and drag the desired FLS-2800
device from the ‘
Discovered devices
’ to
the ‘
Selected devices
’ list to enable
management of this device.
Once you have selected the FLS-2800
device you wish to manage, click ‘
Apply
’
to open the main Tunable Laser
Manager interface.
Figure 6 - Tunable Laser Manager Start-up Device Selection
Note
: If there are no devices listed in the ‘Discovered devices’ list, refer to the Discover section on
page 22 for instructions on how to detect your FLS-2800.
Tunable Laser Manager Interface
1.
Viewing Mode Selection
2.
Content Selection
3.
Main Display
4.
Laser Selection Control
5.
Laser Output Control
6.
Laser Parameter Control
7.
Tool Buttons
Note
: The Laser Selection
Control (4) and Laser
Parameter Control (6) are not
populated until a selection of
laser sources has been made,
see below.
Figure 7 - Tunable Laser Manager Interface (Unit View)
Viewing Mode Selection
To select between
Unit View
and
Chart View
modes, click this drop-down menu and select the
desired mode.
Once selected the
Main Display
will update.
Details on these view modes can be found in
section
Main Display
.
Figure 8 - View Selection Drop-down List
2
3
4
5
6
7
1
