Tunable Laser
Source
FLS-2800
FLS-2800 (v1.1)
12
6.
Connecting Optical Output
I
MPORTANT
To ensure maximum power and to avoid erroneous readings always inspect
fiber ends and make sure that they are clean as explained below before
inserting them into the port. EXFO is not responsible for damage or errors
caused by bad fiber cleaning or handling.
C
AUTION
The type of optical connectors on the FLS-2800 is specific to the model. The
connectors will be of type PM FC/UPC or PM SC/UPC. This information can
be found in
I
MPORTANT
These technical specifications can change without notice.
The information presented in this section is provided as a
reference only. To obtain this product’s most recent
technical specifications, visit the EXFO Web site at
www.exfo.com
.
Table 1 - FLS-2800 Specifications. Joining mismatched connectors will
damage the ferrules.
Cleaning and Connecting Optical Fibers
To connect the fiber-optic cable to the port:
1.
Inspect the fiber using a fiber inspection microscope. If the fiber is clean, proceed to connecting
it to the port. If the fiber is dirty, clean it as explained below.
2.
Clean the fiber ends as follows:
2a.
Gently wipe the fiber end with a lint-free swab dipped in isopropyl alcohol.
2b.
Use compressed air to dry completely.
2c.
Visually inspect the fiber end to ensure its cleanliness.
3.
Carefully align the connector and port to prevent the fiber end from touching the outside of the
port or rubbing against other surfaces. If your connector features a key, ensure that it is fully
fitted into the port’s corresponding notch.
4.
Push the connector in so that the fiber-optic cable is firmly in place, thus ensuring adequate
contact. If your connector features a screw sleeve, tighten the connector enough to firmly
maintain the fiber in place. Do not over tighten, as this will damage the fiber and the port.
