RME1-TC User’s Manual - Thermocouple Acquisition Module
Exemys
D.2. Commands
All commands can be entered in capital or lower case letters.
D.2.1 Password Command
The TCP configuration console and Web configuration interface are protected with a password.
The device’s administrator can assign a password to the device providing a secure method to
access the RME1-TC configuration.
With the PASSWORD command you can change the password from the TCP configuration
console.
Table 9 - PASSWORD command
Command
Description
PASSWORD:password
Changes the access key for remote configuration (TCP command console or
configuration Web Page). The key word must not have more than 10
characters
D.2.2 Host name Command
With this command you can change the device’s name. So that as the device works with the
NBNS protocol, it will be possible to connect to the device (TCP console or web page)through its
name instead of its IP address.
Table 10 - Host name Command
Command
Description
HOSTNAME:name
Changes device’s name. The name must not have more than 15 characters.
D.2.3 NetConfig Command
With this command you can change the network configuration parameters (IP address, netmask
and gateway).With the NETCONFIG command the device will be restarted to produce the
changes. If the console is run from a Telnet session, the communication with the the device will
be interrupted.You will have to reopen the TCP session using the new IP address.
www.exemys.com Rev.
1
Page
36
