11
Adjusting the Slide
The Excy Slide allows Excy to be easily adjusted to your inseam for cycling your legs or to
your height when using Excy as an upper body arm cycle. The configuration is made
possible by pulling out the Slide and locking it into position using the Slide Knob.
1.
Loosen the Slide Knob by turning it clockwise while facing the back of Excy (stop
once you feel increased knob rotation resistance). It requires only a small turn.
2.
Hold the Rear in one hand and use the other hand to hold the Top firmly.
3.
Grab the Slide Bumpers (or the Bar if attached) and pull the Slide out by the Slide
Bumpers (Lightly shaking while twisting back and forth will help with adjusting).
4.
Adjust the Slide extent as is suitable for to your height (25-30 degree angle for
knees 5-10 degree angle for elbows).
5.
Once you have the Slide adjusted as suits to your height, twist the Slide Knob into
a tight position. The Slide Knob only needs to be firmly tightened. Do not tighten
more than necessary to keep the Slide from moving. Over tightening may cause
damage or make it unnecessarily hard to loosen.
6.
To close the Slide, reverse the procedure and push the Slide in until it reaches the
Snap Rivet.
*WARNING! Always have the Slide Knob firmly tightened when using or transporting.
Do not over tighten the Slide Knob (it requires only a small turn to loosen and tighten).
