12
Assembly (add Rivet)
Not applicable in XCS 220 and XCS 240
If you have ordered a version with a Slide (the XCS 260 or XCS 280), it will be shipped
more compressed than intended for normal use. Release the Slide by loosening the Slide
Knob and move the Slide away from the Front until you see the Snap Rivet Hole. Tighten
the Slide Knob to keep the Slide in that position. You will find a Snap Rivet with Washer
held to the clevis area with a rubber band. Hold the top of the Snap Rivet in your hand,
making sure that there is a gap between the bottom of the top and the bottom part of
the snap rivet. Then place the washer over the bottom part of the snap rivet. Then put
the bottom part of the snap rivet (with the washer still in place) into the Snap Rivet Hole.
Then push the top of the snap rivet until it seats against the bottom part of the snap
rivet. It should now be securely in place, and the Slide will not go any farther forward
then where the snap rivet is. This assures the Locking Holes are accessible and the Slide
top does not get paint damage.
*WARNING! Always transport Excy in a closed position with the Clevis and Adjustment
Pin in their locked position.
