Exalt Installation and Management Guide
EX-i Series FDD Digital Microwave Radios
202675-005
49
2011-08-30
Allocation Page
This page allows the administrator to determine how the TDM interfaces (T1, E1, DS3, OC3, etc.) and
remaining Ethernet capacity are allocated when ACM is enabled. Since ACM changes the capacity of
the radio, it is critical to determine how those changes impact the traffic carried over the link.
Figure 31 Allocation page
The left side of the chart shows the different modulations available for ACM. Columns display under
different TDM type column headings (such as DS3 and T1 shown). Selection of how many of each
interface is determined by the selections for each modulation.
The bar graph color codes allocation of the TDM interfaces, showing each interface and the relative
capacity it is occupying. Orange indicates remaining Ethernet capacity for that modulation.
At the right of the graph, the full-duplex Ethernet capacity displays in Mbps. The total full-duplex
capacity displays in the System column.
It may be necessary to configure the TDM interfaces. A link displays under the graph to ease
configuring any TDM interface.
Note:
The allocation of TDM interfaces only defines HOW MANY channels are allocated; it
does not define WHICH physical ports are allocated. Priority of port assignments is
controlled on the
Cross Connect (X Connect) Page
. If a TDM allocation change occurs
between modulations, the priority defined in Cross-Connect determines which ports are
added or dropped.
Summary of Contents for EX i GigE Series
Page 133: ...202675 005 2011 08 30...
