EWS ES2030 SV, Manual, Page: 14 / 39

ES2030 SV Display and modification of the basic settings 11
Display and modification of the basic settings
General information on programming and language selection
On first use, the controller is adjusted to the
operating data of the water treatment system
by entering basic settings. These settings can
be changed and are not lost if power is cut off.
NOTE: All the relevant data can be changed in
programming mode 0. In programming mode 1
only some of the data can be changed, and in
programming mode 2 the cannot be changed
without specialist knowledge (see program
step 22).
- Any alteration to the basic settings should be
carried out by an authorized specialist
engineer.
- Make a note of the basic settings in the
empty spaces in the flowcharts below and
keep this manual carefully for the use of
service and maintenance staff.
- The basic settings can be changed at any
time. However most changed settings can
only be activated after the start of the next
regeneration.
- Some keys have a double function. In
programming modes, the , ,
and # keys are used in combination with the
Enter key.
1. Press the Enter key.
To avoid accidental programming changes,
the key has to be held down for 4 seconds
before the basic values are released for
change.
The LCD display first shows the following
message.
After 4 seconds this changes to:
NOTE: Continue to hold down the Enter key for
functions 2 and 3.
2. At this point you can change the language of
the LCD display as follows:
Press ‘#’ key.
Use the key to move the cursor under the
abbreviation for the desired language.
3. You can move on to the first and
subsequent programming steps using the
key
4. You can move back to previous steps with
the key.
NOTE: The controller is now in programming
mode, and the Enter key should now be
released. To leave programming mode,
press the Enter key again. The controller will
also exit programming mode automatically
approximately 2 minutes after the last key
has been pressed.
5. The cursor is moved with the key.
Yes/No questions are answered by placing
the cursor under Y for Yes and N for No.
For numerical entries use the cursor to
select the digit to be changed.
6. The numerical settings selected with the
cursor can be changed within the preset
values by pressing the ‘#’ key.
NOTE: Programming must be carried out with
the filter in the service position. During a
regeneration there is no programming
possible.
English
D Nl E F Es I
Attention!
Programmechange
Start
Programmechange
#
Enter