Design and function
Machine configuration menu
099-000125-EW501
29.9.2022
59
Display
Setting/selection
Alternative welding start – tapping start
Available from torch mode 11 (welding stop by tapping remains active).
-------- Function enabled (ex works)
------- Function disabled
Up/down speed
> see 5.2.7.8 chapter
Increase value > rapid current change
Decrease value > slow current change
Current jump
> see 5.2.7.7 chapter
Current jump setting in ampere
Machine configuration
Settings for machine functions and parameter display
Operating principle
------
synergic parameter setting (factory setting)
------
conventional parameter setting
Absolute value setting (ignition, secondary, end and hot start cur-
rent)
> see 4.2.3 chapter
-------- Welding current setting, absolute
------- Welding current setting, as a percentage of the main current (ex works)
Non-latched operation (version C)
> see 5.2.8.6 chapter
-------- Function enabled
------- Function disabled (ex works)
Welding current actual value display
> see 4.2.2 chapter
-------- Actual value display
-------- Nominal value display
TIG antistick
> see 5.2.5 chapter
-------- function active (factory setting).
------- function inactive.
Show warnings
> see 7.2 chapter
------- Function disabled (ex works)
-------- Function enabled
Machine configuration (second part)
Settings for machine functions and parameter display
Start ramp
> see 5.4.6.1 chapter
-------- The welding current ramps up to the preset main current (factory setting)
------- The welding current jumps immediately to the preset main current
Responsiveness
> see 5.4.6.2 chapter
------- Linear responsiveness
------- Logarithmic responsiveness (factory setting)
spotmatic operating mode
> see 5.2.8.5 chapter
Ignition by contact with the workpiece
-------- Function enabled (ex works)
------- Function disabled
Spot time setting
> see 5.2.8.5 chapter
-------- Short spot time, setting range 5 ms to 999 ms, increments of 1 ms (ex works)
-------- Long spot time, setting range 0.01 s to 20.0 s, increments of 10 ms (ex works)
Process activation setting
> see 5.2.8.5 chapter
-------- Separate process activation (ex works)
------- Permanent process activation
Torch cooling mode
------- Automatic operation (ex works)
-------- Permanently enabled
------- Permanently disabled
