Operating the machine control
Machine configuration (system)
24
099-00L105-EW501
07.06.2019
Menu i-
tem/parameter
Value
Comment
P26
45 °C
Nominal value of wire spool heater (OW WHS)
0 = -------- off = switched off
1 = -------- setting range temperature: 25°C - 50°C (45°C ex works)
P27
0-1
Operating mode switching at welding start
0 = -------- Not enabled (factory setting)
1 = -------- Enabled
P28
30 %
Error threshold of electronic gas flow control
Error output in case of gas nominal value deviation
Reset to factory
setting:
No
Yes
All special parameters are reset to the corresponding factory setting.
Wire inching ramp time (P1)
The wire inching starts with a speed 1.0 m/min for 2 secs. It is subsequently increased to a ramp function
to 6.0 m/min. The ramp time can be set between two ranges.
During wire inching, the speed can be changed by means of the welding power rotary knob. Changing the
speed has no effect on the ramp time.
Program “0”, release of program block (P2)
The program P0 (manual setting) is blocked. Only operation with P1-P15 is possible, irrespective of the
key switch position.
Display mode for Up/Down welding torch with one-digit 7-segment display (P3)
Normal display:
• Program mode: Program number
• Up/down operation: Welding power (0=minimum current/9=maximum current)
Toggling display:
• Program mode: Program number and welding procedure (P=pulse/n=not pulse) are toggled
• Up/down operation: Welding power (0=minimum current/9=maximum current) and symbol for up/down
operation are toggled
