3704-IG-001 Installation and User Manual
Page 15
Mounting the Model 3704
Removing the Cover
The 3704 EVSE is shipped with the front cover on. Whether wall- or pole-mounting single or dual EVSEs, begin by removing
the EVSE cover to gain access to the four mounting screw holes.
1.
Using a T25 pin-in Torx screwdriver, remove the two screws near the conduit knock-out access holes in the bottom
of the cover (Figure 7A).
2.
Pull the cover slightly out at the bottom of the EVSE (Figure 7B).
3.
Holding the cover at the top and bottom, with the bottom-cover clear of the frame, push the cover slightly up to
clear the cover’s top from the top-rear lip of the EVSE frame (Figure 7C).
4.
With both top and bottom cover tabs clear of the EVSE frame, hold the cover in the middle and pull it straight out
(Figure 7D).
Important! - While pulling the cover out, carefully maneuver both the cover and J1772 cable connector to allow
the connector and “Bee-Guard” to pass through the cover’s access hole (Figure 7E).
5.
When clear of the J1772 cable connector, place the cover in a safe location until needed later.
Figure 7B
Figure 7C
Figure 7D
Figure 7A
Top Lip
Figure 7E
Bee Guard
Optional
Communication Cable
Access Knockout
Optional AC
Power Cable
Access Knockout
