4.
Delay
. Clicking this button will open a pop-up, in which you can set an audio delay of up to 3000ms
for all deembedded channels and for all channels in the respective IP stream. This delay is processed
before the audio goes into the internal Audio Matrix.
5.
Audio Matrix
. This box indicates to which audio channel numbers (groups of 16) the deembedded
audio and ST2110-30 streams are assigned in the internal audio matrix.
6.
IP Audio
settings. In this groupbox, you can configure which of the separate incoming IP audio
streams should enter the Audio Matrix for possible embedding or audio shuffling. The main and
backup inputs can be set up using the same switch-back methods as explained in the Video Paths
tab.
There are two operation modes, 16-channel and 64-channel. Up to 64 channels can be specified
here, which will then be dynamically assigned to the audio matrix channels. In 16-channel mode, 16
channels can be selected from each stream, even when a 64-channel stream is used as the receiver.
26
| February 2022 | Issue 4.9.C
