Step 9
:
Cap the Leg Curl (19) with two 2" Sq End
Plugs (43). Insert two 1/2" Steel Bushings
(52) into the hole in the Leg Curl (19).
Attach the Leg Curl (19) to the Seat
Support (18) using the 1/2" Axle (61), two
5/16" x 5/8" Sunken Head Screws (79),
two 5/16" Spring Washers (80) and two
5/16" Washers (81). Insert the Bolster
(12) into the hole in the Leg Curl (19) and
secure with the 5/16” x 1/2” Sunken Head
Bolt (68). Slide one 4" Foam Pad (27) onto
each end of the Bolster (12) then cap both
ends of the Bolster (12) with a 1" End Plug
(44) as shown in FIG 15. If the Foam
Pads (27) are difficult to slide onto the
Bolster (12) try applying a small amount
of soapy water to the Bolster (12) prior to
sliding on the pads.
assembly instructions
-16-
ASSEMBL
Y
FIG-15