Step 5
:
Attach the Adj Back Bracket (11) to the
Upright (3) using the 3/8" x 3" Hex Head
Bolt (65), four 3/8" Washers (75) and
the 3/8" Nylon Nut (77) as shown in FIG
10. Secure the Adj Back Bracket (11)
in place using the Pop Pin (56).
Slide the EVO Band (82) onto the Back
Pad (26). Slide the Back Pad Hinges
(13) onto the Adj Back Bracket (11).
Make sure the holes are on the bottom
then attach the Back Pad (26) to the
Back Pad Hinges (13) using two 3/8" x
3/4" Hex Head Bolts (73) and two 3/8"
Washers (75) as shown in FIG 11.
Insert the Bolster (12) into the sleeve
welded on the Adj Back Bracket (11)
and secure with the 5/16" Sunken Head
Screw (78). Slide two 100 mm Foam
Pads (27) onto the Bolster (12). If the
Foam Pads (27) are difficult to slide onto
the Bolster (12) try applying a small
amount of soapy water to the Bolster
(12) prior to sliding on the pads. Cap
both ends of the Bolster (12) with a 1"
End Plug (44) as shown in FIG 12.
ASSEMBL
Y
assembly instructions
-12-
FIG-10
FIG-11
FIG-12