XRF1/XRF1A 16x16 RF Router Manual
XRF1 - 6-2
Revision 1.2
VISTALINK
6.1.3. Specifications
6.1.3.1.
Serial I/O (COM 1)
Standard:
RS-232
Connector:
Female DB-9
Baud Rate:
57600
Format:
8 bits, no parity, 2 stop bits, no hardware flow control (COM2 not available)
6.1.3.2. Ethernet
I/O
Standard:
IEEE 802.3 (10BaseT), IEEE 8002.3u (100BaseTx)
Connector:
1 RJ45
Cable Requirements:
10 Base T:
UTP category 3, 4 or 5 cable up to 328ft/100m (2 pairs)
100 Base Tx:
UTP category 5 cable up to 328ft/100m (2 pairs)
6.1.3.3. Electrical
Voltage:
100-240VAC, 50/60 Hz auto-ranging
Power:
11 Watts
EMI/RFI:
Complies with FCC Part 15, class A and EU EMC directive.
6.1.3.4. Physical
Size:
17 1/8” W x 4 3/8” D x 3 ½” H (435mm x 111mm x 89mm)
Weight:
4 lbs. (1.81 kg)
Temperature:
0 to 50 deg. C. (Operating)
6.1.4. X-NCP2
Configuration
Menu
When power is applied to the unit, the X-NCP2 provides a set-up menu with the following parameters:
<back>
Conveniently located at the start and end of a menu stack, this menu item allows the
user to return to the previous menu for further configuration, if required.
Network Setup:
Set the IP address of the X-NCP2 unit, its subnet mask and gateway IP.
Configuration:
N/A
Service:
N/A
Reboot:
A menu option that allows the user a quick way to reboot the X-NCP2 unit without
unplugging the AC power source from the unit. Options are “yes” and “cancel”.
Discovery:
N/A
Add Frame:
Menu option to add routers to the X-NCP2 control list
Remove Frame:
Menu option to remove routers from the available list.
Request update:
N/A