EverFocus EBC890, User Manual

Page: 18 / 64

10
10 10
10
Hardware Installation
In this chapter, after preparing for the installation, the user is ready to begin the install. This
section will describe, in general terms, how to install the hardware including wiring. Here are
the following processes:
•
Mount the support frame and controller
•
Connect the electric strikes or magnetic locks
•
Connect the door sensor
•
Connect the request-to-exit button
•
Install and connect the card reader (optional)
Mounting Fingerprint Controller
The fingerprint controller has a built-in reader working as an entry reader, so it should be
installed close to the door where it guides. As a common rule, the fingerprint controller
should not be installed on a metal, which will lower the card sense range.
The fingerprint controller package contains a supporting frame to elevate the controller in
order to make wire connections more convenient. The installation is described in the steps
below:
Step 1: Mount the supporting frame on to the wall.
Use the four anchor screws (provided in the package) to mount the frame to the wall.
Show it as the
Fig. 6.
Step 2: Make cable hole
In the terminal area, marked as 1 in step 1 of the figure, make a hole on the wall, big
enough to allow all the wires go through. Note the wiring diagram will be addressed in the
following sections. Wire all the required cables before step 3.
Step 3: Mount the fingerprint controller to the supporting frame
Align the fingerprint controller to the 4 latches (marked as 2 to 5 in step 1 figure) on the
frame, and attach the controller to the frame (marked as 1 in step 2 figure). Make sure the
Chapter
3