4
THE EVOLUTION OF PORTABLE OUTDOOR COOKING
APPLIANCE DETAILS
Gas Type:
ULPG
N.G
Burner Pressure:
2.75 kPa
1.0 kPa
Injector Diameter:
Ø1.00 mm
Ø1.60 mm
Heat Input:
12 MJ/ hr
12 MJ/ hr
Note: The size of the injector diameter is stamped on one of the hexagon faces (e.g. ‘165’ for Ø1.65mm injector).
*NOTE: the length increases by 147mm per servery when the serverys are folded out fully. **NOTE: the length increases by
138mm per servery when the serverys are folded out fully.
Air is admitted at the underside of the combustion chamber (a 200mm x 20mm gap between the fat tray and
the chamber through an oval hole 65mm x 45mm in size). Air is also admitted around the burner (3cm²) on
the right hand side & at the viewing/manual ignition hole (radius 8mm) on the left hand side. Exhaust gases are
emitted around the edge of the hot plate (5mm gap) and through a 250mm x 20mm slot in the rear of the
hood. When using an open grill, aeration also takes place through the slots of the grill.
GAS CONNECTIONS
LOCAL AUTHORITY REQUIREMENTS
Check Gas Type and specifications plate on the inside of the left-hand side trolley door. All gas fitting work,
service and repairs can only be performed by an authorized person in accordance with AS5601 and local gas
regulations. Hose connections are 1/4BSPP for ULPG & 1/2BSPP for NG
NATURAL GAS
E2go barbecues can be converted to use natural gas ONLY with an e2go NG conversion kit. Fit the NG
manifold (with valve), regulator and NG hose following the supplied instructions. Conversion of any barbecue
from ULPG to NG (or vice versa) must be done by a licensed gas fitter/technician. Refer to AS5601 for piping
sizes. Please contact Everdure for further information.
FOR ULPG CYLINDER CONNECTION
1.
To achieve the optimum performance from your Everdure Barbecue, an approved gas cylinder (POL fitting) of
4kg or 9kg capacity must be used. Always run the hose through the steel loop, to help keep it away from the
hot barbecue,
2.
Do not connect gas to a barbecue that is not secured in the supplied trolley or on a stable raised surface.
The Cylinder must be placed in the centre of the trolley when one is used. The cylinder should be lower than
the barbecue & in a protected place when not using a trolley.
3.
Connect the cylinder to the barbecue, via the hose and regulator. Firmly tighten joints, but do not over-
tighten. Take care not to damage the regulator fitting. Check that the gas control knob/valve is in the Off
position before opening the gas cylinder.
NOTE: Only one gas cylinder should be stored in the trolley at any one time.
LEAK TESTING
1.
Make sure the gas control knob is Off and turn the cylinder valve On.
2.
Check for leaking joints by brushing with solution of half-liquid detergent and half water. If a leak is present,
bubbles will appear (or you may hear a hissing sound). Retightening connections can generally repair a
leaking joint. You must also check the gas hose and connection at the gas cylinder. If a leak cannot be
resolved, do not proceed.
DO NOT USE NAKED FLAME FOR LOCATING GAS LEAKS.
IF A LEAK PERSISTS CALL AN AUTHORISED GAS FITTER.
Barbecue only
LENGTH (mm)
WIDTH (mm)
HEIGHT (mm)
870*
502
388
Barbecue and Trolley
888**
502
983
3
4
