__________________________________________________________________________________________________________________
Series GA201-M2
12
LT126 June 2021
5. Please refer to the illustrations below for clarity in this step:
a. Lift the pole assembly with the head attached, upwards. The housing top cover will come with it as
there is packing underneath to hold the top cover in place while you lift the pole up.
b. Rotate the pole so that the mounting flanges almost line up with the cut-out on the base plates.
Once the top mounting flange is above the surface, rotate the pole so the holes line up with the
threaded bolts.
c. Lower the pole assembly onto the bolts so that they come through the holes on the mounting
flange. Make sure the front of the heater is facing the Even-GLO faceplate on the front of the base.
Note: Housing cover is not shown below for ease of illustration.
Figure 5: Pole and Housing Assembly
6. Take the contents out of hardware bag EH089. Slip the washers on the threaded bolts (6 washers). Secure
the pole assembly by threading the lock nuts (6 lock nuts) onto the threaded bolts and tighten with a
wrench or socket.
7. Remove the 4 screws in the Heater Base housing and use them to attach the housing top cover. Carefully
take off the packaging holding the housing top cover up the pole. Slide the top cover down the pole,
covering the pole mounting flange and hardware. Use the 3/32” allen key to tighten, located in hardware
bag EH089.
8. Locate the Wheel Kit. Open the packaging and take the wheel assembly and the hardware provided out.
Locate the two mounting holes on the Main Base. Line up the wheel assembly as shown in Figure 6 below.
Insert both bolts into the matching set of mounting holes. Tip the heater slightly to be able to thread on the
nylon nuts provided underneath the main base. Tighten the nuts until the wheel assembly is secure.
