20
GB
GB
GB
GB
GB
5 . 8
5 . 8
5 . 8
5 . 8
5 . 8 MANUAL RESET OF THE ALARM
MANUAL RESET OF THE ALARM
MANUAL RESET OF THE ALARM
MANUAL RESET OF THE ALARM
MANUAL RESET OF THE ALARM
If the alarm has been configured as a latched
alarm, the alarm status persists even after the
alarm condition disappears.
To reset the alarm, press the pushbutton to
select the parameter “
n.rS
” (the display will show
“
n.rS
” and “
OFF
”. Use the and
pushbuttons to select “
ON
” and press the
pushbutton.
The alarm reset action will only be successful if
the alarm condition has disappeared only.
SP/SP2 or TIMER CONTROL
SP/SP2 or TIMER CONTROL
SP/SP2 or TIMER CONTROL
SP/SP2 or TIMER CONTROL
SP/SP2 or TIMER CONTROL
(This parameter is skipped if P27 is = 0)
Lower display:
stS
Upper display:
OFF
= Status OFF
-
On
= Status ON
5.9 “Soft Start” FUNCTION
5.9 “Soft Start” FUNCTION
5.9 “Soft Start” FUNCTION
5.9 “Soft Start” FUNCTION
5.9 “Soft Start” FUNCTION
At power up, the instrument will measure the
process variable and compare the measured
value with a programmed threshold (see P10
parameter in chapter 4).
If the measured value is lower than the pro-
grammed value, the instrument will limit the
maximum output power (see OLH operative
parameter) for a programmed time (see tOL
operative parameter).
If tOL is equal to InF, the limiter is ever active.
5.10
5.10
5.10
5.10
5.10 LAMP TEST
LAMP TEST
LAMP TEST
LAMP TEST
LAMP TEST
To check the display efficiency, press pushbuttons
+ . The instrument will turn ON, with a
50% duty cycle, all the LEDs of the display (this
state is called LAMP TEST).
No time out is applied to the LAMP TEST.
To return to the normal display mode, press
pushbuttons + again.
No other keyboard functions are available during
the LAMP TEST.
5 . 1 1
5 . 1 1
5 . 1 1
5 . 1 1
5 . 1 1
FUNCTION OF THE
FUNCTION OF THE
FUNCTION OF THE
FUNCTION OF THE
FUNCTION OF THE
PUSHBUTTONS
PUSHBUTTONS
PUSHBUTTONS
PUSHBUTTONS
PUSHBUTTONS
Saves the new value of the selected
parameter and goes to the next
parameter (increasing order).
Enables or disables the SMART
function and scrolls back all the
parameters without saving them.
Increases the value of the selected
parameter or (0216 only) displays the
set point value or the measured
value.
Decreases the value of the selected
parameter.
02-0316-1-DER.pmd
22/04/2004, 16.19
20
