14
GB
GB
GB
GB
GB
Timer mode 7 [P27 = 8]
Timer mode 7 [P27 = 8]
Timer mode 7 [P27 = 8]
Timer mode 7 [P27 = 8]
Timer mode 7 [P27 = 8]
The instrument starts in "Power OFF" mode and
it remains in "Power OFF" mode until a transfer
from open to close of the logic input is detected.
When the instrument detects the transfer from
contact open to close it starts the control using SP
set point and starts the time count down.
NOTES:
NOTES:
NOTES:
NOTES:
NOTES:
1) The guarantee soak function can be applied to
this timer mode (see P28 parameter)
2) The transfer from "Power OFF" mode to
AUTOMATIC mode starts the "Soft start" and
the "alarm masking" functions (if programmed).
When the time count is equal to 0 the instrument
comes back to the "Power OFF" mode .
For other details see paragraph "5.7 Timer
"5.7 Timer
"5.7 Timer
"5.7 Timer
"5.7 Timer
modes description".
modes description".
modes description".
modes description".
modes description".
P28 – BAND FOR TRACK
P28 – BAND FOR TRACK
P28 – BAND FOR TRACK
P28 – BAND FOR TRACK
P28 – BAND FOR TRACK
(Present if P27 is greater than 2)
0.1 / 50.0 for input range 5
1 / 500 for all other input ranges
Above max value the display shows
“
OFF
” meaning that the tracking is
disabled
5 .
5 .
5 .
5 .
5 . OPERATIVE MODE
OPERATIVE MODE
OPERATIVE MODE
OPERATIVE MODE
OPERATIVE MODE
The display and modification of the operative
parameters can be protected by a secret code.
For more information see section 4.2.
5 . 1
5 . 1
5 . 1
5 . 1
5 . 1 PRELIMINARY COMMENTS
PRELIMINARY COMMENTS
PRELIMINARY COMMENTS
PRELIMINARY COMMENTS
PRELIMINARY COMMENTS
It is assumed, at this point, that the instrument
has been correctly configured as indicated in
Section 4.
- Model 0316 displays the measured value on the
upper display: the lower display is normally
used to display the operating set point (below
this condition is defined as “Normal display”) or
the remaining time (when the timer is running).
- Model 0216 displays:
- the measured value (below this condition is
defined as “Normal display”) or
- the operating set point (in this case the SP
led lights up) or
- the remaining time when the timer is running
(in this case the decimal point on the left hand
the LSD will flash).
To change from the display of the set point to
that of the measured value, or vice versa, press
pushbutton .
All the parameters can be displayed sequentially
by pressing the pushbutton.
- Model 0316 displays the abbreviated name of
the selected parameter on the lower display, on
the upper it will display the selected value.
- Model 0216 displays alternately the name of
the parameter and its value: during the
modification it displays only the value.
02-0316-1-DER.pmd
22/04/2004, 16.19
14
