Eurotherm Drives 584S, Product Manual, Page: 100 / 176

Chapter 4 -SETTING-UP AND COMMISSIONING
584S Frequency Inverter 4-35
ERROR REPORT This is a read only diagnostic showing communication errors as follows:
ERROR
REPORT MEANING
00C0 No errors
01C7 Unknown mnemonic
02C2 Block check character fail
03C1 Parity error on received data
03C2 Framing or overrun error
05C8 Attempt to write to a read-only mnemonic
07C7 Invalid message format
08C8 Value in selection message out of range
PNO.7 Control word for multi-parameter polling. See Appendix B Block 0, PNO.7
for a description. Range: 0x0000 to 0xFFFF.
Default: 0xFFFF.
PARITY
Select odd or even parity (Main Port P1 only). Eurotherm BISYNC protocol
requires even parity, however odd parity may be selected for other
applications. Default: EVEN.
OPTION VERSION
The
OPTION VERSION
diagnostic indicates the software/firmware version of
the field bus options.
AUX Port P3
Parameters available from the AUX Port P3 menu are as follows:
SRL LINK ENABLE
Enables serial port operation. Note that this parameter must be enabled before
serial communications can take place.
GROUP ID (GID) Eurotherm protocol group identity address. Range: 0 to 7. Default: 0.
UNIT ID (UID)
Eurotherm protocol unit identity address. Rang e: 0 to 15. Default: 0.
PROTOCOL
There are two types of message format (protocol),
EI ASCII
and
EI
BINARY
. This parameter selects which format is to be used. Default:
EI
ASCII
.
BAUD RATE Baud rate is the serial communications bit rate. Range: 300 to 9600. Default:
9600.
ESP SUP(ASCII)
See Appendix B for a description of ESP support.
CHANGEBAND(BIN)
Enquiry poll changeband. See Appendix B Block 0, PNO.4 for a description of
Changeband.
Range: 0.0% to 327.6%.
Default: 0.0%.
This manual was downloaded on www.sdsdrives.com
+44 (0)117 938 1800 - info@sdsdrives.com