DuraMAR 2150 – User’s Manual
HSDPA interface information
The current status of the HSDPA interface can be retrieved using the
show interface hsdpa0
command in
User Mode
:
HSDPA-rt#
show interface hsdpa0
Interface hsdpa0 is Enabled physical status is PPP up
Hardware type is HSDPA modem
Network in use : HSDPA Cat. 6 (3.6Mbps)
IP address is 91.80.172.179 255.255.255.255
link gateway is not set
MTU 0 bytes qdisc is
From the output of this command the user will known: the interface status (
enabled
or
disabled)
, the PPP link
status (
up
or
down)
, the IP address provided by the ISP and the type of network in use (
GPRS
if 2G or
UMTS, EDGE or HSDPA
for 3G networks).
Cellular network information
You can get detailed information about the current status and availability of the cellular network for the
hsdpa0
interface issuing the command
show modem status
in User Mode.
From the output of this command the user can know almost everything about the status of network
registration.
Here is an example of the output of this command in a good 3G coverage area:
HSDPA-rt#
show modem status
Current status for modem interface hsdpa0
Current Time: 131566 Temperature: 50
Bootup Time: 57997 Mode: ONLINE
System mode: WCDMA PS state: Attached
WCDMA band: IMT2000 GSM band: Unknown
WCDMA channel: 10564 GSM channel: 65535
GMM (PS) state:REGISTERED NORMAL SERVICE
MM (CS) state: IDLE NORMAL SERVICE
WCDMA L1 State:L1M_DCH RRC State: CELL_DCH
RX level (dBm):-70
This is the output of the
show modem status
command in an area with no 3G coverage:
HSDPA-rt#
show modem status
Current status for modem interface hsdpa0
Current Time: 8904 Temperature: 47
Bootup Time: 2 Mode: ONLINE
System mode: WCDMA PS state: Attached
WCDMA band: IMT2000 GSM band: GSM900
WCDMA channel: 10638 GSM channel: 65535
GMM (PS) state:REGISTERED LIMITED SERVICE
MM (CS) state: IDLE LIMITED SERVICE
WCDMA L1 State:L1M_PCH_SLEEP RRC State: DISCONNECTED
RX level (dBm):-104
Note the LIMITED SERVICE values for GMM and MM fields and the DISCONNECTED RCC state.
23
