DuraMAR 2150 – User’s Manual
The relevant fields in the output of this command are:
Temperature
The internal temperature of the ECC HSDPA module
System mode
GPRS (2G) or WCDMA (3G)
GMM and MM state
NORMAL SERVICE or LIMITED SERVICE
RCC_STATE
The registration status, CELL_DCH, CELL_FACH, DISCONNECTED (for 3G networks only)
RX level
The quality of the signal received by the module
SNMP configuration
The system can be monitored using the SNMP protocol. Only SNMP version 2c is supported. The available
information includes:
•
the current 3G network type used by the
hsdpa0
interface
•
the signal quality on the
hsdpa0
interface
•
the internal temperature of HSDPA modem
•
the internal temperature of CPU
SNMP traps are sent to the configured manager host if the temperatures of the HSDPA module or the CPU
exceed a predefined fixed value and whenever there is a change on the 3G network type.
The basic configuration of the SNMP agent requires only the definition of a
community name
and the
enabling of the service. Here are the required steps:
1.
configure
2.
snmp-server community private
3.
snmp-server enable
4.
exit
The complete list of commands available for the SNMP agent configuration is listed below:
snmp-server community
string
Sets the community name (
this is a mandatory step
)
Sets the contact name
snmp-server contact
string
Sets the locations of the device
snmp-server location
string
Sets the logical name of the device
snmp-server name
string
Sets the IP address of the management station
snmp-server host
ip-address
Enables the SNMP agent service
snmp-server enable
You can view the SNMP server status and configuration issuing the
show snmp-server
command.
System administration
Changing 'admin' user password
The user can change the password that is used to protect the
admin
user logon.
While in Configuration Mode, the
passwd
command is used to perform the change. The user will be asked for
the new password to be assigned to the admin user. The password is not echoed on the screen for security
reasons. Moreover, the
passwd
command is not shown in either running or start-up configuration files.
24
