DuraMAR 2150 – User’s Manual
The commands are represented by the text of the SMS message. Available commands:
SERCPU
Connects the GPRS modem serial interface to ECC
ttyS1
interface
Connects the GPRS modem serial interface to the
AUX
port of the
CISCO 3200 ISR
SERCISCO
Force a hardware reset of ECC.
RESETCPU
Force a complete system reset with power-off/power-on cycling.
RESETALL
When a new SMS message is received, the subscriber number is checked against the available entries in
the phonebook and the command is executed only if the number is verified.
Phonebook entries can be managed from ECC CLI using the
set phone-book
command.
The complete syntax of the command is:
set phone-book <item> <number>
item
identifies the entry and must be a number between 1 and 4
number
is the authorized subscriber number and must include the international prefix (es. +39)
An item can be removed from the phonebook using the
no-form
of the command. For example the following
command will remove the item at position 2:
no set phone-book 2
In order for the changes to be written to the GPRS modem you must issue a
copy running
command,
otherwise any change will be lost after a system restart.
During the execution of this command, the
gprs0
interface must be disabled, otherwise the modem phone-
book can't be updated because the interface is in use by the ECC controller.
In case you are using a startup configuration with
gprs0
interface enabled you must:
1. disable
the
gprs0
interface first
2. apply changes to the phone-book entries
3. save the running configuration using the
copy running
command
4. enable
the
gprs0
interface
5. issue
a
copy running
command again
In this case there is no need for accessing the GPRS serial interface during the execution of the
copy
running
command because the phone-book is unchanged.
Since the phone-book is loaded from the modem only when system is powered-on, after any change to the
phone-book entries the system must be switched off and then switched on again in order for the changes to
take effect.
Note:
Wait for about 30 seconds before switching on again
31
