DuraMAR 2150 – User’s Manual
13
Chapter 2 Physical Installation
Physical installation may only be performed by trained and authorized personnel. The electrical installation
must adhere to local regulation requirements. The instructions for use must be followed at all times.
Installation considerations
•
The device must not be accessible to passengers nor operational staff (excluding maintenance).
•
The unit must be placed such that there is sufficient space for connecting the cables and removing the
protection cover.
•
A minimum clearance of 50mm around the device should be ensured in order to avoid possible
overheating. The space required by the connectors and cables can be up to 90mm, therefore sufficient
space should be reserved for installing the system.
•
The device must be secured firmly. A device that is inadequately fixed may cause danger to people or
other equipment in the vehicle. The safety instructions of the vehicle must be followed rigorously.
•
The device must be mounted inside an appropriate equipment cabinet.
•
The device can be fixed in any orientation (vertical, transversal and longitudinal)
The DuraMAR-2150 anodized enclosure is built from two extruded aluminium parts. The outside dimensions
excluding connectors are:
Length (mm)
Width (mm)
Height (mm)
254
129
83
Square nuts (as shown in the diagram below) are mounted within slots on the system casing and therefore
can be positioned in a location to best suit the customer’s requirements.
Figure 4.
Slots and Square nuts dimensions (mm)
SQUARE NUT M4 INOX A2 DIN562
105
= =
243
