Eureka MAGNUM HDK, User Manual

Page: 19 / 90

20
1. RED LED: PRE HEATING OF FUEL
2. KEY SWITCH
3. BUTTON FOR FILTER SHAKER
4. VACUUM CUT OFF BUTTOON
5. ACCELERATION LEVER
STARTING UP ENGINE
Before starting the engine be sure that the main brush is lifted from the ground.
If lowered the starting motor will not start.
Accelerate 1/3 of the lever pos.5
Turn the key pos.2 a clockwise way, until the led of the fuel pre heating turns
on.
Keep key in position until the led turns off.
Continue with the clockwise rotation until the motor starter functions, not for
more then 5 sec. If the engine does not start at the first time, repeat procedure
with intervals of 10sec.
Bring back acceleration lever pos.5 to its minimum for at least 3-5min.
Keep acceleration lever to MAX always when working.
TURNING OFF ENGINE
Bring acceleration lever pos.5 to the minimum position
Turn key pos.2 in position 0.
FILTER SHAKER CONTROL
THE QUALITY OF THE WORK OF THE SWEEPER IS STRONGLY
INFLUENCED BY THE STATE OF THE FILTER AND ITS CLEANNESS.
IT IS RECOMMENDED TO SHAKE IT OFTEN, ESPECIALLY IF THE
AREA TO SWEEP IS VERY DUSTY.
You can clean the filter in 3 ways :
While the engine is on.
Bring acceleration lever pos.5 in min position.
Cut off vacuum with the lever pos.4.
press filter shaker button pos.3 for 5-10 seconds
Repeat operation sevral times
While the engine is off.
Turn key pos. 2 into position 1.
press filter shaker button pos3 for 5-10 seconds
Repeat operation sevral times
in an automatic way
The sweeper is equipped with an automatic filter shaker. Once that the sweeper is
turned off, the filter shaker will be activated automatically. The time of the shaker
can be regulated.
IF THE HOPPER IS LIFTED ALL THREE SYSTEMS WILL NOT
WORK.