ETS Sunvision Elite 48V, Owner'S Manual

Page: 34 / 40

29
26851-01A
roubleshooting
Problem Solution
Unit not tanning
Lamps fail to light and timer dis-
play is blank
Timer display changes to indicate
a tanning time after the timer but-
ton is pressed but lamps do not
come on
My booth is connected to the T-
Max® Manager remote system
and when the delay time has
expired the timer display starts
counting down but the tanning
lights do not come on
My unit won’t work with the T-
Max® Manager remote system
Timer display continues to show a
0 after the timer button is pressed
The last minute of tanning time
does not count down from 59
seconds, but some time less than
59 seconds
1. Clean unit, see Thorough Periodic Cleaning .
2. Ensure supply voltage is between 208 and 230V AC.
3. Replace lamps if lamp hours are greater than 800hrs.
1. Make sure the unit is connected to a power source.
2. Check source of AC power. Reset circuit breaker or replace fuse.
1. Bypass plug is not installed, see Electrical Connections .
2. A non-SunStar® bypass has been used. See Electrical
Connections .
3. If remote is being used, other than T-Max® Manager, the exter-
nal timer may not be activated.
4. Remote wiring is incorrect, see the instructions provided with
the remote interface kit.
The auto start feature of the remote system is disabled, see the
instructions provided with your remote system.
1. The unit must first be set to a unique address, see Remote
Connections .
2. The bypass or terminator plug may be installed in the series in
an inappropriate location. Remove the bypass plug when
using T-Max® products.
1. T-Max® Manager remote system has not yet been set.
2. Unit address is not set correctly, see
Remote Connections .
If the timer button has been pressed to decrease tanning time
during the session, the time expired in the current minute is
subtracted from the last minute.