ETS Sunvision Elite 48V, Owner'S Manual

Page: 32 / 40

26851-01A
27
Care and Maintenance - Hour Counter
Hour Counter
The SUNVISION Elite™ 48V incorporates
an ingenious hour counter function into
the timing circuitry. It allows the operator
of the unit to monitor the hours of use of
the lamps, making it easy to determine
when to change them. You may also
decide to use this function to monitor
other time based maintenance tasks.
To determine how many hours the unit
has been in service (since the last reset of
the hour counter memory), first make sure
the timer display shows “0”. Then simply
hold the stop button for three seconds.
The display will show two pairs of num-
bers which indicate the number of hours
of service, then return to “0”. (example:
Display shows 08 then 54. This equals
854 hours.) NOTE: If the unit is connect-
ed to a T-Max® remote device, it may
briefly lose communication with the
remote. This is normal.
To erase the indicated hours disconnect
power from the sunbed. Press and hold
the green timer button as you reconnect
power. Release the button after a few
seconds.
Mechanical Inspection
Your tanning booth has been built for years
of service. To ensure trouble-free operation
throughout its life, inspect the unit’s
mechanical integrity every 400-500 hours
of use.
• Inspect the unit’s fasteners verifying
that all are firmly in place.
• Inspect door hinges for signs of wear. If
your hinges squeak you need only
replace the bronze bushings. See
Troubleshooting .
• Inspect the AC power cord and its
connections.