26851-01A
28
Lamp and Grill Maintenance
Introduction
To be assured of maximum tanning effec-
tiveness, change lamps after approximate-
ly 800-1000 hours of use. Tanning will
continue after this time but at a slower
rate. To ensure trouble-free operation of
your booth, replace the lamp starters
whenever the lamps are replaced.
Removing/Replacing Metal Grills
The metal grills are secured in place by
two screws at the top of each grill. Simply
remove these screws and lift the grill out
of its channel at the bottom. Repeat for
the other grills. The long inside handles
will also need to be removed to remove
the left and right module grills. The lamps
are now exposed.
After changing the lamps, replace the
metal grills by reversing the directions.
Removing/Replacing Lamps
After removing the metal grills, replace
lamps as follows.
Step 1
Grasp the lamp at one end and
at the middle and turn the lamp
one quarter turn. Gently remove
the lamp from its holders.
Step 2
Reinstall the lamp by inserting
the pins located on the ends of
the lamp into the slots on top of
the lamp holders and turn the
lamp a quarter turn. It should
click in place.
Recommended Replacement Lamps
We recommend using the lamps specified
below. Use of uncertified lamps is a viola-
tion of Federal regulations and will void
your warranty. These lamps have an aver-
age life of 800-1000 hours of effective
tanning use. Lamps used longer than that
begin to lose their effectiveness even
though they continue to light.
THE FOLLOWING LAMPS HAVE BEEN CERTIFIED FOR USE IN THIS EQUIPMENT:
BRONZING SUN™ Wolff® Model BS71-T12-160W VS-R BI-PIN
WARNING
Shock hazard.
Disconnect power before removing
any protective covers.
Care and Maintenance - Lamp and Grill Maintenance
Summary of Contents for Sunvision Elite 48V
Page 1: ...26851 01A...
Page 36: ...31 Notes 26851 01A...
Page 37: ...26851 01A...
Page 38: ...26851 01A...
