26851-01A
24
Operation - Using Your Booth
1.
Open the doors, step inside and close the
doors fully. For best results, position your
body in the center of the booth.
2.
Put on your safety goggles.
3.
Assuming the remote system has been set
to allow a pre-tanning delay time, the timer
display (A) will repeatedly flash the delay
symbol “dL” and then the remaining delay
time. Press the timer button (B) or wait until
the delay time has expired to begin the tan-
ning session. The lamps will turn on and
the timer will begin to count down.
4.
If a tanning time less than the displayed
time is desired, repeatedly press the timer
button (B) to decrease the remaining time.
5.
When the timer reaches 0 the lamps turn
off. If you want to stop your session before
time expires, press the stop button (C).
6.
Exit the booth. If you become disoriented
there are “EXIT” signs over the doors. The
cooling fans run for a period of time after
the lamps shut off to aid in cooling the
booth. The timer will indicate “..” as a
reminder to clean the tanning surfaces.
After the booth is cleaned, press the timer
button and the display will return to “0”.
Using Your Booth
When connected to the T-Max® Manager or T-Max® 1A or 3A.
A Timer display
- Displays remaining time.
B Timer button
- Turns unit on. Timer dis-
play shows remaining time. If a lesser
time is desired, press timer button until
desired time is displayed.
C Stop button
- Interrupts tanning session.
WARNING
Wear protective eyewear.
Failure to may result in severe burns or
longterm injury to the eyes.
A
B
C
Summary of Contents for Sunvision Elite 48V
Page 1: ...26851 01A...
Page 36: ...31 Notes 26851 01A...
Page 37: ...26851 01A...
Page 38: ...26851 01A...