7 / 16
5.4 ENTER THE ALLARM MENU:
a) The controller must be set on MANUAL operation and all capacitors must be OFF.
b) Press the button
for 5 seconds.
c) The display will show
66(7
d) The LED
and
will flash with intermittence of 500ms.
e) Press both buttons together
and
for 2 seconds until the display shows
67
.
$
f) The LED
and
will flash with intermittence of 500ms.
g) Press the button
for 5 seconds.
h) The display will show
$
.
+X
i) Press the button
for to enter in alarm’s parameter, shows the
(
.
QE
.
j) Press the button
for to enter for set the value.
k) Press the button
to increase or the button
to decrease the value.
l) Press the button
for to enter in alarm’s parameter, shows t
he
G
.
W
.
m) Press the button
for to enter for set the value.
n) Press the button
to increase or the button
to decrease the value.
o) Press the button
for to enter in alarm’s parameter, shows the
G
.
X
.
p) Press the button
for to enter for set the value.
q) Press the button
to increase or the button
to decrease the value.
r) Press the button
for to enter in alarm’s parameter, it shows the
G
.
s) Press the button
for to enter for set the value.
t) Press the button
to increase or the button
to decrease the value.
u) Press the button
display will show
$
.
+X
.
v) Press the button
for to get another alarm.
w) Repeat the procedure from point
“
i)
”
to set the parameters
x) When the display will show
$
.
&6
, to exit the Alarm Menu, press
to save the data, display will show
6$8
and exit the Alarm Menu.
y) All LEDs will flash for a few seconds.
z) If the display shows
(55
, it means that an error has happened and wasn’t possible to save the data.
Therefore it will be necessary to program again all the parameters on the Alarm Menu.
For a quick exit from the menu, press
for 3 seconds until display shows
6$8
ETI Elektroelement d.d. - Slovenija
Tel.: 03/56-57-570- Fax: 03/56-74-077
www.eti.si - [email protected]
