ETC Sensor3, Retro-Fit Manual

Page: 13 / 20

The Retrofit 11
Connect Dimmer Output Adaptors to Dimmer Output Cables
1: For each of the ribbon cables (1, 2, or 4 depending on your enclosure type), connect the
transition card edge connector to the ribbon cable.
• Pin 1 of the enclosure ribbon cable is marked by an arrow on the connector, which
corresponds to an arrow on the transition card at J2/pin 1.
2: Sit the adapter in the plastic protection box.
3: Fit the cover of the plastic protection box by snapping the lid on.
4: Plug the end of the upgrade cable into the correct header on the new backplane.
Note:
The red stripe on the enclosure ribbon cable and the red stripe on the upgrade cable
do not align. They are on opposite sides.
Match the arrow on the enclosure
ribbon cable connector to the
arrow at J2/pin 1 on the transition
card and be sure the proper side
is up.
Step 1
red stripe
red stripe
arrow, J2/pin 1
arrow
"INSTALL THIS SIDE UP"
Step 2 Step 3
"INSTALL THIS SIDE UP"
Connect dimmer output cable to the numbered location
Rear of backplane
1
2
3
4