ETC QuickTouch+ 12, User Manual

Page: 22 / 32

18 Qui Control Station User Manual
Moving to Trims
Recorded trims are reached using normal motor movement, (see Moving Motors, page 12 ).
When a moving motor reaches an intermediate trim position (Trim 1, 2, or 3) it stops movement.
If the up [

] or down [

] button is released and pressed again the motor will continue movement
past the trim position.
If the High or Low Trim is reached, motor movement will stop. To resume motor movement, you
must press the button to move the motor in the opposite direction of the limiting trim.
Moving to trims from the Trim Menu
You can instruct a motor to temporarily ignore other trims and move to a specified trim using
the Trim Menu.
Once instructed, the other intermediate trims (Trims 1-3) will be temporarily deactivated so that
the motor can move directly to the specified trim without interruption. Once the specified trim is
reached, the other trims will be re-activated. In any situation, High and Low trims are not
affected and remain in full effect when programmed.
To move to a trim without interruption from other trims:
Step 1: Select a motor using the motor select button. The motor information will appear
in the LCD and the select LED will illuminate white.
Step 2: Press [Trim] . The “Select Trim” menu will appear.
Step 3: Turn the menu knob to highlight the desired trim and press the menu knob to
select it. The motor trim command options appear.
Step 4: Use the menu knob to highlight “Move to Trim” and press the menu knob to select
it. The Motor Status Screen will again be displayed and the other trim position
markers will be temporarily removed from the position bar graph. Only the
selected trim marker will appear.
Step 5: Press and hold the desired up [

] or down [

] button to move the selected motor.
Movement will continue until the selected trim (or High or Low trim) is reached.
Once the trim is reached, the other trims will be reactivated.