Etaluma, Inc. | 3129 Tiger Run Court, Suite 112 | Carlsbad, CA 92010 | 760-298-2355 | www.etaluma.com
5.
Unplug the power and USB cable from the LS720. Slide shipping lock
into position at front of deck just left of the Deck Knob (Fig 1) so the
2 holes in the shipping lock line up with 2 holes on the front
underside of the deck. Screw in the two 1-inch screws (Fig 3) until
tight using the supplied 3 mm hex wrench (official torque is 16 in-
pounds).
6.
Tighten the 4 set screws in the shipping lock with the 3 mm hex
wrench until they are just touching the plate carrier, then tighten a
further quarter turn (top 2 screws, Fig 2) and deck surface (bottom 2
screws, Fig 3). Do NOT over tighten. Set screw head to be
approximately even with shipping lock surface.
7.
Test by gently trying to lift plate carrier at front where it is being held
by shipping lock. If plate carrier can be lifted at front, tighten the two
1-inch screws and then the 4 set screws a little more until plate carrier
is securely locked.
