eta cancetta, Instructions For Use Manual

Page: 25 / 92

Control
- Plug the power cord M to a socket. You will see the ETA sign on the display, then
the iron is switched automatically to the stand-by regime and the STAND-BY sign is
shown on the display.
- Set the selected program (i.e. the fabric material) using the control.
By pressing the control at the place marked with the
+
symbol you increase the
temperature and by pressing the control at the place marked with the
-
symbol you
reduce the temperature.
- The respective information is shown gradually on the display using signs and symbols
(fig. 9).
- Increasing (
왖 왖
) or reducing (
왔 왔
) the temperature is signaled by a flashing symbol.
- Reaching the proper temperature is signaled by the TEMP.OK sign and a sound signal.
Sound signaling
- Every pushing of the control in requirement for setting the fabric material beyond the
allowed pre-set range = "1 very short beep".
Note: when setting the STAND-BY program, every other pushing of the - control is
without any effect, when setting the PWR JEANS program, every other pushing of
the + control is without any effect.
- Every pushing of the control (i.e. change of the program) = "1 short beep".
- Reaching the temperature of the set program = "1 long beep".
- Activation of the safety function AUTO-STOP = "permanent beeping".
Ironing without steaming
Put the iron to the rest position (fig. 7). Turn the steaming regulator D to the 0 position,
steaming off (fig. 5) or pour out water from the container I . Plug the power cord M to
a socket. Set the program on the display using control H according to the selected fabric
material (Fig. 2). Reaching the required temperature is shown on the display and
announced by sound signaling.
Warning
Control H (Fig. 2) is marked with international symbols that recommend the optimum
ironing temperature and they are the same as marking on some types of laundry and
textiles (Fig. 3). When the temperature is increased from the cold state or if the
temperature is set from higher to lower, we recommend waiting for a while (see the
information on the display and listen for sound signaling) due to stabilization of the ironing
plate temperature.
Never turn the control, set programs only by light pushing of the control at places
marked with symbols plus (+) and minus (-).
Steam ironing
Hold the iron disconnected from power supply in your hand, turn steaming regulator D to
0 position (Fig. 5) and lift off cover C to open the filling container lid. Pour in water to
container I using the enclosed cup N (Fig. 4) and close the filling hole lid in the opposite
direction. Keep the position of the iron for pouring in water. Plug power cord M to
a socket. Put the iron into the rest position (Fig. 7) and using control H set one of the
programs enabling steaming on the display (i.e. WOOL, COTTON, MAX or PWR JEANS).
When you hear a sound signal (indicating reached selected temperature), move regulator
25
GB