GB
46 / 81
–
The power cord must not be damaged with sharp or hot objects, open fire, it must not be
sunk into water or bent over sharp edges. Never put it on hot surfaces or do not let it hang
over the edge of a table or work tables. Hitting, stumbling or pulling the power cord e.g. by
children can result in tilting over or drawing the appliance down and serious injury!
–
If you need to use an extension cord for justified reasons, it must be undamaged and
comply with the applicable standards.
– Check the condition of the power cord of the appliance regularly.
II. FEATURES OF THE DEVICE (pic. 1)
A – bread maker
A1 – control panel
A3 – ventilation openings
A2 – baking space
A4 – supply cord
B – lid
B1 – visor
B3 – ventilation openings
B2 – handle
C – baking form
C1 – foldable handle
C2 – shaft
D – kneading hook
E – tool for taking out the hook
F – measuring spoon
(5/15 ml)
G – measuring cup
(200 ml)
III. CONROL PANEL (pic. 2)
1) DISPLAY
After turning on the device the display will show basic settings “1 3:10“ (i.e. program
BASIC
)
and sound a signal.
-
number 1 shows which program has been chosen
-
number 3:10 shows the preparation time of the chosen program
-
position of the arrow gives information about the chosen colour of the bread baked
(
/ /
= LIGHT / MEDIUM / DARK)
-
position of the arrow gives information about the chosen weight of the bread baked
(500 g / 750 g / 1000 g)
After the bread-maker is connected to the mains, the basic setting is the
KLASIK
programme (basic), weight: 750g, crust darkness: MEDIUM. The numbers of the set time
decrease with the process of the program. After the programme is finished,
0:00
will appear
on the display, and the bread maker will switch to the temperature maintenance mode for
one hour.
0:00
will remain on the display (the colon between digits is blinking). After auxiliary
heating is ended, the programmed time will appear on the display (the colon between digits
is not blinking).
2) The
START/PAUSE/STOP button
The button is used to start, pause and stop the programme. When you press the
START/PAUSE/STOP
button, the colon between the digits will start flashing and
the programme will start. When you shortly press the
START/PAUSE/STOP
button
again, the programme will pause. To indicate that the programme is paused, the
time and colon will be flashing. After holding the
START/PAUSE/STOP
button for
approximately 3 seconds you will hear a sound (long beep) and the program will be
stopped. You may use this function even for ending the 60min heat-up of the device.
