GB
35 / 44
MA01708100
Settings with the ESY Control app
Pulse:
When movement has been detected and the level of ambient light is
below the configured brightness switching value, the red LED flashes once,
the relay opens for one second and the closes again for nine seconds.
For the MD 230° / MD 280° devices, a switch-off delay time based on
the direction of movement can be configured in addition to the standard
switch-off delay time. With this setting, different switch-off delay times
can be set depending on the direction of movement of the detected person.
The following directions are available:
•
Movement from left to right (from the perspective of the sensor)
•
Movement from right to left (from the perspective of the sensor)
•
Movement towards the sensor
•
Movement away from the sensor
If a movement cannot be clearly categorised, because multiple people
are in the field of detection, for example, the standard switch-off delay
time is used.
Crawl protection must be activated in order to use the
< Depending on direction of movement >
setting.
Setting options: < 1 min - 240 min >
Acknowledgement:
The lighting switches on. The detector LED provides
various feedback signals during transmission. After the changes have been
completed, the green detector LED flashes three times to confirm this.
The lighting then switches off.
7.2.6 Motion sensor sensitivity
The motion detector is equipped with a highly sensitive passive infrared
sensor. In this setting, you can adjust the general sensitivity of the sensor
to limit the field of detection on an individual basis.
The field of detection of the motion detector can also be adjusted by
horizontally or vertically aligning
the moveable lens (MD 200°) or the
sensor head (MD 230° / MD 280°). It can also be mechanically adjusted
using the supplied lens mask.
