13
The relationship is as follows:
For each state, the desired heating temperature and fan speed
must be set. Section 7 provides information on the CV numbers.
Furthermore, you can still set when the transition to drive to ac-
celeration drive occurs after coast is cancelled. The corresponding
thresholds define the acceleration or deceleration values, from
which the smoke generator is to change the mode. Finally, the mi-
nimum in the SUSI mode, the maximum steam burst length, and
the duration of the bursts of steam can be adjusted in proportion
to their distance.
6.3. Firmware update with LokProgrammer
Of course, the ESU smoke generator using the ESU LokProgram-
mer can be supplied with a new firmware. For this purpose, the
smoke generator must be removed, however, and then connec-
ted to the LokProgrammer. Two separate solder connections are
available for this. These are marked «PROG». Figure 17 shows
where they are located. These two connections to the output must
be connected to the LokProgrammer.
7. Support and help
If you do not know how to proceed, first contact your dealer whe-
re you purchased your ESU product. He is your competent partner
for all questions about model trains.
In difficult cases, you can contact us directly. Look first on our
website under «Support / FAQ» to see whether the question has
already been answered. If this is not the case, we ask you to make
these available to us either in our support forum or to contact us
by e-mail. We also provide a telephone hotline, which should only
be used in the case of really special requests.
Germany
By phone:
+49 (0) 731 - 1 84 78 - 106
Tuesday & Wednesday
from 10.00 to 12.00 o‘ clock
By Fax: +49 (0) 731 - 1 84 78 - 299
By E-Mail:
www.esu.eu/kontakt
By mail:
ESU GmbH & Co. KG
Edisonallee 29
D-89231 Neu-Ulm
www.esu.eu
USA
ESU LLC
By phone:
+1 570-980-1982
By Fax:
+1 866-591-6440
By E-Mail:
By mail:
ESU LLC
23 Howard Street
Montoursville PA 17754
www.loksound.com
Programming
54678 & 54679 solder connections for LokProgrammer
Figure 17:
