
APPENDIX A
SOFTWARE COMMANDS
Revised: 10 Oct 2017
APX A-4
ESTeem Models 195MHC
global (on/off)
This function will set the ability of the ESTeem to receive or not receive global messages (address = 255). Factory default = off.
on =
Enabled.
off =
Disabled.
gw_addr (*IP Address)
This command sets the Gateway address in the ESTeem 195M/H/C.
ident
This command sets the modem identification for the ESTeem 195M/H/C. This is a simple alpha-numeric value set in the modem
for easy identification in the network. This command can take up to 12 characters long and could be used for site name, location
or any value to easily identify. Factory default = <blank>.
ip_addr (*IP Address)
This command sets the IP address for the ESTeem 195M/H/C. Factory default = 172.16.8.1xx (where xx is the last two numbers
of the serial number).
maxbsywait (25 to 225)
The maxbsywait command sets the limit for the time the modem will wait when a carrier is detected. The units of time are
1/50
th
of a second. Factory Default = 150
model
Displays the product model of default firmware that is installed. Model should be the same as product being used.
netmask (*IP Address Netmask)
The netmask command sets the IP netmask for the ESTeem 195M/H/C. This command is used in conjunction with the ip_addr
and gw_addr commands to complete IP address for the ESTeem. Factory default = 255.255.0.0
network (0-255)
Network identification code. This is used to program a common code for all modems in the customers network so that another
facility on your frequency using the same addresses will not interfere with your equipment. Factory default = 37.
packdump (on/off)
This function enables monitoring of the data sent through the configured serial device interface (SDI). This troubleshooting tool
can be used to verify the operation of the wireless network by looking at both serial devices exchanging data. Factory default =
off.
on =
Enabled.
off =
Disabled.
packleng (1-2000)
This command defines the length of the data packet in bytes. Factory default = 2000.
packmon (on/off)
Places the ESTeem in the packet monitor mode. The packet monitor modem will allow the user to monitor all wireless packets
by their source, destination and repeaters. Please refer to ESTeem Packet Monitor Engineer Report for complete details on the
operation of this feature. Factory default = off.
Summary of Contents for 195C
