ESTeem 195C, User Manual, Page: 38 / 75

CHAPTER 6
UTILITIES & FEATURES
Revised: 15 Feb 2017 6-6 ESTeem Models 195MHC
Update Firmware
The 195C, 195M and 195H firmware is updated by pressing the Update
Firmware button on the Firmware tab of the utility. The firmware
version is tied to the release version of the utility and is listed below
the address (Figure 10). The release of any new firmware version will
be listed on the products web site address:
http://www.esteem.com
Model 192 Compatibility
The 195C and 195M require “training” to operate with legacy ESTeem
Model 192C, 192CHP, 192M or 192MHP wireless modems. The
training process and network installation procedures are found in
Appendix C (Model 192 Integration) of this User’s Manual.
Programming Console
The 195 Series Narrow Band Configuration Utility has a console window to allow direct access to enter and modify software
commands. The console uses Telnet to the 195M/H/C and will link to the modem when the Console tab is selected. If
communication is lost to the modem (on reset) you may have to press the Connect button to again see the command prompt
(CMD:).
Diagnostics
The diagnostic menu tests the wireless communication
between multiple ESTeem 195M/H/C or Model 192 series
wireless modems. The diagnostic test will send multiple sized
data packets to the test addresses listed and also measure the
receive signal strength wireless link. Press the Add Units to
Test button to enter the destination ESTeem addresses or you
can enter a range (example 20 ‐ 26 is all addresses 20 through
26) in the “Radios to Test” box (Figure 11). Pressing the Start
Tests button once will begin the testing and pressing again
will stop the testing.
The diagnostic screen will show the instantaneous results of
the testing such as which site is being polled and the current
signal strength. All diagnostic information can be saved by
pressing the Print Results button.
Figure 10: Save and Load Configuration
Figure 11: Save and Load Configuration
Technical Tip : The Diagnostics will not
function if the Model 195M/H/C is in
Ethernet Bridge Mode. Use a standard
TCP/IP Ping utility to test the reliability of
the wireless link.