ESTeem 195C, User Manual, Page: 35 / 75

CHAPTER 6
UTILITIES & FEATURES
Revised: 15 Feb 2017 6-3 ESTeem Models 195MHC
The Advanced Configuration tab will allow you direct access to
any of the individual software commands in the ESTeem 195M,
195H or 195C. The following sections describe the individual
tabs and how they are used.
Read Configuration
The 195 Series Narrow Band Configuration Tool provides a
graphical interface to the individual software commands for
the ESTeem 195C or 195M. On the Configuration tab the
software commands can be displayed by their category.
All ‐ Display the status of all software commands (Figure 5)
Change – Display commands changed from factory default
Network – Ethernet network commands
Interface – Port configuration commands
PLC – PLC emulation commands
Radio – Radio configuration commands
Pressing the Read Config button with any of the above radials
selected will display the commands associated with the
selection.
Read Remote 195C or 195M Configuration
The software commands can read in the same way from a remote ESTeem 195M/H/C through the wireless network. A direct path
entry or repeater route can be used to read the configuration. For example in Figure 7, the commands listed were read from
ESTeem address 184 using address 183 as a repeater (183,184). If the repeater routes are already defined for the network (using
the Route/Append tables), you can just enter the destination address and check the Use Route from Append Table check box.
Write Configuration
Any software command displayed after reading the configuration can be modified. Once the commands have been changed, press
the Write Config button. The modem will save the changes and reboot. The wire configuration can also be sent through repeaters.
For example in Figure 7, the commands listed were written to ESTeem address 184 using address 183 as a repeater (183,184). If
the repeater routes are already defined for the network (using the Route/Append tables), you can just enter the destination
address and check the Use Route from Append Table check box.
Reset Unit
Pressing the Reset Unit button performs the same action as pressing the Reset button on the face of the 195M/H/C. The modem
will discard any unsaved commands and read the program from the non ‐ volatile memory. This can be performed on a remote
ESTeem.
Factory Defaults
Pressing the Factory Defaults button will reset the software commands to factory default settings (see Appendix A for all default
values). Factory defaults does not reset address, frequency or squelch settings.
Figure 5: Advanced Configuration menu